+7 (812) 645-08-06
Chamfer gauge - max. 1.25" | 68x series
These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the gage may be adjusted to read the proper number. 1-2 Range In case of wear, the gage may be adjusted to read the proper number.When the three-blade plunger is pressed against a flat surface, the gage should read the set number stamped on the back of the indicator
No setting master is necessary
Internal gages will measure the largest diameter of any chamfer that has an included angle within the range of angles printed on the dial face
Gages are also available with electronic indicators on request
Deluxe Padded Case
All ground surfaces are of hardened tool steel
Indicators are AGD design