+7 (812) 645-08-06
Gas sampling probes
select brand
Gas sample line - 230 V, 700 W | HKL
The IAG heated or cooled line(HKL) with flexible construction and stainless steel seal allows undisturbed measurement results and even sample points, with easy access to them . It is the perfect sampling line, which...
Gas sample line - 230 V, 700 W | HKL
The IAG heated or cooled line(HKL) with flexible construction and stainless steel seal allows undisturbed measurement results and even sample points, with easy access to them . It is the perfect sampling line, which...
Cooled sampling probe / flue gas - FGAII ChillerProbe
The ChillerProbe combines a quality heated filter with a sample cooler to clean and dry flue gas. The device can only transfer dry gas to the FGAII stack gas emissions analyzer. This...
Cooled sampling probe / flue gas - FGAII ChillerProbe
The ChillerProbe combines a quality heated filter with a sample cooler to clean and dry flue gas. The device can only transfer dry gas to the FGAII stack gas emissions analyzer. This...
Gas sampling probe / heated - SONDE HOFI
This gas sampling system, hot extractive stack, is connected...
Gas sampling probe / heated - SONDE HOFI
This gas sampling system, hot extractive stack, is connected to heated analyzers like MIR FT. It is helpful in Municipal and hazardous waste incinerators, and plants like combustion, petrochemical, cement, glass, and paper mills.
Gas sampling probe - ø 27 mm, 60 cm | MS1 PROBE
The MS1 Probe is a gas sampling system that is used in combination with low concentration analyzers. They have a low sampling rate which...
Gas sampling probe - ø 27 mm, 60 cm | MS1 PROBE
The MS1 Probe is a gas sampling system that is used in combination with low concentration analyzers. They have a low sampling rate which prevents clogging problems and provides an immediate dilution at the sampling point. This device is capable of transferring sample has up to 150 m using an unheated line which provides no condensation. The MS1 calibrates the control of the monitoring system by injecting the span gas directly at the top of the probe. It needs little to no maintenance and has a low installation cost.