Washers

select brand


GAMM

Plastic washer - RO series

The insulating washers are made from red or black thermoplastic. Both the black...

Plastic washer - RO series

The insulating washers are made from red or black thermoplastic. Both the black and red colors are available in stock. The insulating washers are available in diameters ranging from 8 to 12.5 mm. Designed by GAMM, the varying dimensions of these insulating washers make them suited for a wider range of applications.
Misumi America Jergens & Acme

High load capacity washer

Jergens presents USAE™ heavy duty flat washers. USAE is a combination of USS and SAE.

A USAETM washer is a simple yet effective concept, which has been in need for a long time.

The outside...

High load capacity washer

Jergens presents USAE™ heavy duty flat washers. USAE is a combination of USS and SAE.

A USAETM washer is a simple yet effective concept, which has been in need for a long time.

The outside diameter is in conformance with USS standards. When compared to standard hardened washers, the washer has up to 36% larger area. The increased contact area results in increased holding power. The inside diameter is in conformance to SAE standards. A more accurate fit on bolts, studs, etc. is achieved by this reduced internal diameter. In comparison to standard hardened washers, USAE washers provide more strength thanks to their 37% more thickness.

The USAE™ washers have a mild steel body with a black oxide finish and the case is hardened to 60 HRc. To enable quick identification, every washer has the bolt size stamped on it.

Lashing washer

The Equalizing "C" Washers from Jergens are equipped with a knurled O.D., and...

Lashing washer

The Equalizing "C" Washers from Jergens are equipped with a knurled O.D., and are parallel to the ground with both faces. It is constructed out of low carbon steel with a sleek black oxide finish.

Their hard cases can withstand extreme heat.

They are offered in FixtureProTM Design Software and PartSpec CD.

Cone washer

These washers are perfectly suitable for unification of appliance sections which are out of parallel. They correct themselves for a positive, solid bottom. By means of...

Cone washer

These washers are perfectly suitable for unification of appliance sections which are out of parallel. They correct themselves for a positive, solid bottom. By means of radius E and the angular 140 grouping, line contact is shaped about the two friendly washer planes, enabling the two washers the skill to look for wrong alignment in the mating washer constituents. The temperature treated I.D. of the base curved in part is bigger than the I.D. of the top u-shaped part for liberated action. It is accuracy earth and the pointed edges are eliminated. Fabric: 303-grade Stainless Steel or Low Carbon Steel, Black Oxide finish and case toughened temperature treat.
{{item.name}}