+7 (812) 645-08-06
Screws
select brand
Stainless steel screw / shoulder
Stainless Steel-Shoulder screws ISO 7379 are cost-saving construction elements for a wide variety of different uses.
The...
Stainless steel screw / shoulder
Stainless Steel-Shoulder screws ISO 7379 are cost-saving construction elements for a wide variety of different uses.
The maximum tightening torque is limited by the relatively small bearing points (shoulders) and by the recesses at the transition point from d1 to d2 and d3.
Standard deviation:
- Concentricity 2 IT 13 and 2 IT 10
- the official ISO standard sheet has the following dimensions for d2 - d1: M5-6,5 / M10-13 / M20-25.
The maximum tightening torque is limited by the relatively small bearing points (shoulders) and by the recesses at the transition point from d1 to d2 and d3.
Standard deviation:
- Concentricity 2 IT 13 and 2 IT 10
- the official ISO standard sheet has the following dimensions for d2 - d1: M5-6,5 / M10-13 / M20-25.
Screw
Ganter GN 606 steel-pall point screws are available in different versions.
Type AN with full...
Type AN with full...
Screw
Ganter GN 606 steel-pall point screws are available in different versions.
Type AN with full ball is suitable for applications in need of a ball point contact.
Type BN has a flat-faced moving ball that allows non parallel surfaces to be clamped or supported.
Type VN/VRN has balls that swivel "maximum of 9, thereby maintaining the clamping always on the ball's flat section.
Type AN with full ball is suitable for applications in need of a ball point contact.
Type BN has a flat-faced moving ball that allows non parallel surfaces to be clamped or supported.
Type VN/VRN has balls that swivel "maximum of 9, thereby maintaining the clamping always on the ball's flat section.
Screw with eye
mbo Osswald GmbH & Co KG had been developing and manufacturing precision engineered superior quality workpieces and parks quickly and economically. The quality and efficiency of these products are unrivalled because the...
Screw with eye
mbo Osswald GmbH & Co KG had been developing and manufacturing precision engineered superior quality workpieces and parks quickly and economically. The quality and efficiency of these products are unrivalled because the new machinery is noted for its high flexibility, repeat accuracy and short machining times. This allows for economic production of simple workpieces and when it comes to geometrically complex parts, especially of high tensile steels having minutely toleranced dimensional and surface specifications. Different lengths of rod and shaft parts ranging from 4 - 65 mm and reaching a total length of 650 mm can easily be manufactured. The device makes it easy to execute cross-holes, turned grooves, millings, multiple-edge turning and complicated geometries. Other versions of the model are available. Short delivery times guaranteed with pilot, small-lot or mass production.