+7 (812) 645-08-06
Shaft alignment system - PCE-TU 3
The shaft alignment PCE-TU 3 was developed for the optical alignment of shafts in equipment and machinery, the shaft alignment is intended for use so that shafts can be examined in plants and thus can be optimised, through the shaft alignment system PCE-TU 3 should be achieved that the relative position of two coupled machines such as a motor and a pump, changed so that the axis lines of the shafts are aligned in normal operation, in the measuring process with the shaft alignment system PCE-TU 3 it will use two laser probes which measure horizontal and vertical displacement and angular deviation, other parameters such as thermal expansion and tolerances can be taken into account with the shaft alignment , and spacers can be simulated, also included are soft foot measurements, cardan mode and surface flatness of the repertoire from the aligner, after the values have been measured you will be shown on the large display from the pulley alignment device before you have the possibility to put it into the 2 GB memory card to save it, with either USB or Bluetooth the measured values are then very easily transferred from the shaft to a computer, there the measured data from the shaft can be analyzed further and evaluated, to support this a data analysis software is included.