+7 (812) 645-08-06
Expandable chuck - ø 8 - 235 mm, ø 1.5 - 5 mm | T-EP series
Use: turning, grinding, balancing and inspection operationsHigh degree of expansibility 1.5 to 5 mm depending on the diameter of the sleeve
Possibility to clamp worpieces with diameters ranging from 8 to 235 mm
Clamping takes place as follows :
the worpiece is placed in the centre of the sleeve,
and the workpiece and sleeve are slid together
until they are lightly clamped, then the rear end
of the tapered arbor is struck against a piece of wood
to obtain tighter clamping.
To separate the workpiece from the sleeve,
hold the workpiece and sleeve in one hand
and strike the smaller end of the arbor.