+7 (812) 645-08-06
Forging press / double motor / press - 12500 - 63000 kN | PK 3150
DescriptionThe DualDrive concept for crank presses makes it possible to move through the top dead center position at a very low ram speed, and move through the bottom dead center position at a very high ram speed. The forging press is equipped with two drives for this kind of high-performance.
Main drive. A conventional main drive with flywheel, clutch / brake combination with freewheel and planetary gear unit.
Auxiliary drive. A controlled auxiliary drive for the sections in which no forging takes place. With this drive concept, called DualDrive, it is possible to vary the ram speeds between 6 and 12 strokes / min. in the TDC area and between 60 and 120 strokes / min. in the BDC area. As a result, the die contact times can be cut to a minimum, thereby extending the die life.
Also, the time available for die cooling and for parts transport is longer. This means the productivity of the press can be increased significantly by full capacity utilization. Output rates of up to 40 parts / min are possible, depending on the part size.
Your advantages
The die contact times can be cut to a minimum, thereby extending the die life
Also, the time available for die cooling and for parts transport is longer
The productivity of the press can be increased significantly by full capacity utilization