+7 (812) 645-08-06
Welding system wire feeder - HWP-50E
The HWP-50E Hot Wire Process is used where high deposition rates, combined with high quality are needed. Used with the GTAW or PAW welding process, the wire is electrically preheated before it enters the weld pool. The system can be used for the surfacing or the joining of ferrous and non ferrous alloys.Produces high quality welds in either hot wire or cold wire mode
Enhanced control of heat input
Primarily for GTAW and PAW processes to yield deposition rates similar to GMAW
User friendly 9629HW microprocessor control; designed for presetting and sequencing of wire feed speed
Wire feed speed range is 12 to 600 IPM (30 to 1525 CPM) with a speed holding accuracy of 1%
Heavy-duty four roll wire drive unit
Dual-axis wire positioner
Several hot wire torch designs available including narrow groove
Feeds wire sizes from .045” and .062” (1.2 and 1.6 mm)
100% duty cycle, 200 amps at 10 volts AC variable frequency power supply
Current and volt meter
0 to 15 volt open circuit voltage
Easy primary three phase switch over - 380/415/460 volts, 50/60Hz
System includes hot wire power supply, remote control, wire drive, wire feed accessories, wire straightener, standard torch, cables and hoses