Hardware tools for electronics development

select brand


Johnson Electric

Developer's Kit - 3 - 24 V, 2.3 A | Evaluation Kit 2

This Saia Evaluation Kit 2 is designed for motors type and suited for distribution markets.It can be used for international catalog distributors with dimensions of 164x130x45 mm.It features...

Developer's Kit - 3 - 24 V, 2.3 A | Evaluation Kit 2

This Saia Evaluation Kit 2 is designed for motors type and suited for distribution markets.It can be used for international catalog distributors with dimensions of 164x130x45 mm.It features stepper drive systems optimization,test and development and also has a windows-based software.It also features a quick parameter setup with visualization of speed and position.This can be used for both unipolar and bipolar motors and has positioning sequences capability.It comes with 3 step modes: full, half and micro while control inputs to 3-digital inputs,4-signal outputs,1-analog input 0 10 VDC and 1 relay contact.It can be applies motor current or constant current drive with a configuration of RS 232 and phase current up to 2,3A.
maxon motor

Hardware starter kit - 120 W | EPOS2

The EPOS2 Module features one major advantage which is the flexibility, since it can...

Hardware starter kit - 120 W | EPOS2

The EPOS2 Module features one major advantage which is the flexibility, since it can be used in a number of operational modes therefore allowing the use of the module in wide range of drive systems. Maxon introduces the EPOS2 Module Starter Kit which includes the following 361435,275829,360665,275851, 275934,275878 and 350392.
CML Microcircuits

Evaluation kit - PE0002

The PE0002 EvKit interface card is a global interface system for use with evaluation kits for CML's new generation ICs, including FirmASIC-based products.
This greatly simplifies the approach to the evaluation...

Evaluation kit - PE0002

The PE0002 EvKit interface card is a global interface system for use with evaluation kits for CML's new generation ICs, including FirmASIC-based products.
This greatly simplifies the approach to the evaluation and design-in process.

Based around the operation of Hyperstone's E2 32-bit RISC/DSP Microprocessor and using a PC GUI, the information generated is formatted, timed and delivered to the target IC via its Evkit's C-BUS serial interface. The supplied control software can be used to perform C-BUS read and write operations or to run scripting functions.

In the case of FirmASIC IC evaluations, the Function Image can be loaded onto the CMX{target} device or programmed into serial memory on the {target} card.

Communications with the evaluating PC GUI are via a USB port.
{{item.name}}