+7 (812) 645-08-06
Magnetic angle sensor / dual output - AN9 series
DescriptionNon-contact, intrinsically linear contact angle position sensors with two independent outputs. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output (ratiometric to the input voltage) corresponding to an angular rotation of the input shaft
Features
Angular position sensor with high tolerance for misalignment
Non-contact angular position sensing and full 360⁰ rotation
Dual independent (redundant) outputs assure high reliability
Custom programming available for: angle range, slope, PWM output, custom magnets – contact factory
No mechanical interface means no parts to wear out or jam
Comes with 18 AWG 305 mm (12”) wire leads
RoHS Compliant
IP67
Maximum air gap of 5.5 mm (0.22”)*
*with AS500106 magnet carrier
Typical Applications
Implement (fork lift, agricultural trailer hitch, etc.) position sensing
Steer, throttle by wire
Gear selection
Zero-contact encoder alternative